Long time lurker, first time poster...
I have a Jerry can that I want to restore for everyday use. Its very solid, however the original tan liner in it has come off in spots and is bubbling in others. I want to strip it completely out so it doesn`t contaminate the fuel. Iv`e seen other threads on rust removal, but i don`t recall / can`t find anything on removing the original liner. Anybody have any success with a particular product or process? Thanks!
Liner removal
- Ez8
- G-Second Lieutenant
- Posts: 521
- Joined: Tue Jul 31, 2012 4:01 pm
- Location: Indiana, United States
Re: Liner removal
If you can find a place that does electrolytic stripping (basically, dunking the can in electrolyte solution and shooting electricity through it) I reckon that'd do it. I bet a radiator shop could clean it out for you as well. Any place near you that refurbishes fuel tanks could likely help you out. Most big cities will have a place that does that kind of work.
Good luck and let us know how it goes!
Good luck and let us know how it goes!
MB# 215159 D.O.D 2-25-43
Build Thread: viewtopic.php?f=96&t=209632
Build Thread: viewtopic.php?f=96&t=209632
- Cyclefreak13
- G-Sergeant First Class
- Posts: 99
- Joined: Thu May 13, 2010 1:51 pm
- Location:
Re: Liner removal
I had to remove tank liner from a motorcycle tank. I just used deck screws thrown inside. I then wrapped the tank up in heavy blanket and placed it in my dryer, stuffed some towels in around it to hold it firm to the drum so it wouldn't bounce around. Ran it on cold and let it tumble for an hour. It got most of the liner out and I was able to reline the tank after that.
Devin
1943 Converto 0650749
1945 MB 407114
G519 (Replica)
The G.I. Bike
Cushman 34 G679
1943 Converto 0650749
1945 MB 407114
G519 (Replica)
The G.I. Bike
Cushman 34 G679
Who is online
Users browsing this forum: No registered users and 29 guests