Any Condition.
Please email me directly.
Thanks
WTB GP Drivers side radiator air deflector
Moderator: DavidA
-
- G-Major
- Posts: 901
- Joined: Fri Dec 13, 2002 8:16 pm
- Location: Columbus, OH
- Jacco
- G-Colonel
- Posts: 1971
- Joined: Fri Dec 13, 2002 2:17 pm
- Location: The Netherlands
I know a guy who is really good in sheet metal. He makes several things for me right now. Including the plates for the rubber hood blocks.
He's bussy right now, but I'm sure he could make some air deflectors for you!.....let me know If I should ask, could take a few months though..
He's bussy right now, but I'm sure he could make some air deflectors for you!.....let me know If I should ask, could take a few months though..
Jacco
1940 Ariel W/NG
1941 Ford GP
1943 BSA M20
1945 Royal Enfield WD/CO
1940 Ariel W/NG
1941 Ford GP
1943 BSA M20
1945 Royal Enfield WD/CO
Drivers side deflector
Hello
Could you send a pic or tell me of a site so I can see if what I have is what you are looking for.
Thanks Todd
Could you send a pic or tell me of a site so I can see if what I have is what you are looking for.
Thanks Todd
GP DEFLECTOR
Jim Causey has a pretty good selection of reproduction sheet metal for GPs. I remember seeing right and left deflectors in his parts flyer. His prices are reasonable as well.
Best Regards,
John W. Rymark
CPO USN RET
Best Regards,
John W. Rymark
CPO USN RET
-
- G-Major
- Posts: 978
- Joined: Mon Dec 16, 2002 6:01 am
- Location: Palmetto, Georgia
JIM CAUSEY PARTS
Richard, good to see you online. Have appreciated my parts from you. Richard, do you have a GP pintel hook? Please contact me at crymark@aol.com
Jim Causey can be contacted for GP reproduction parts, in California, at 530.532.9206
Best Regards,
John
Jim Causey can be contacted for GP reproduction parts, in California, at 530.532.9206
Best Regards,
John
-
- G-Major
- Posts: 901
- Joined: Fri Dec 13, 2002 8:16 pm
- Location: Columbus, OH
Thanks John,
I sure appreciate it. I was hoping that I might be able to line up an original before buying the repro. May end up going that route though.
Jacco, If jim is making them, then there is probably no sense in your guy making them as well. That is a VERY generous offer though. Do you think he could make the battery tray bracket? Not the tray itself, but the part that elevates it off the frame. Also might want to consider the gas tank shield. I think these are two parts that no one is making at the moment. and I know several people who could use them.
Brian
I sure appreciate it. I was hoping that I might be able to line up an original before buying the repro. May end up going that route though.
Jacco, If jim is making them, then there is probably no sense in your guy making them as well. That is a VERY generous offer though. Do you think he could make the battery tray bracket? Not the tray itself, but the part that elevates it off the frame. Also might want to consider the gas tank shield. I think these are two parts that no one is making at the moment. and I know several people who could use them.
Brian
Brian
Who is online
Users browsing this forum: No registered users and 49 guests