WTB GP Drivers side radiator air deflector

1940 - 1941 BRC, MA, GP, Preproduction Prototypes. Knowledge Base NO EBAY or COMMERCIAL SALES.

Moderator: DavidA

Post Reply
Brian Wolf
G-Major
G-Major
Posts: 901
Joined: Fri Dec 13, 2002 8:16 pm
Location: Columbus, OH

WTB GP Drivers side radiator air deflector

Post by Brian Wolf » Fri Jun 13, 2003 9:27 pm

Any Condition.
Please email me directly.
Thanks
Brian


User avatar
Jacco
G-Colonel
G-Colonel
Posts: 1971
Joined: Fri Dec 13, 2002 2:17 pm
Location: The Netherlands

Post by Jacco » Sat Jun 14, 2003 4:39 am

I know a guy who is really good in sheet metal. He makes several things for me right now. Including the plates for the rubber hood blocks.

He's bussy right now, but I'm sure he could make some air deflectors for you!.....let me know If I should ask, could take a few months though..
Jacco

1940 Ariel W/NG
1941 Ford GP
1943 BSA M20
1945 Royal Enfield WD/CO

Todd Mccrimmon

Drivers side deflector

Post by Todd Mccrimmon » Sat Jun 14, 2003 6:38 am

Hello
Could you send a pic or tell me of a site so I can see if what I have is what you are looking for.
Thanks Todd

John W. Rymark

GP DEFLECTOR

Post by John W. Rymark » Fri Jun 27, 2003 6:05 am

Jim Causey has a pretty good selection of reproduction sheet metal for GPs. I remember seeing right and left deflectors in his parts flyer. His prices are reasonable as well.

Best Regards,
John W. Rymark
CPO USN RET

Richard Grace
G-Major
G-Major
Posts: 978
Joined: Mon Dec 16, 2002 6:01 am
Location: Palmetto, Georgia

GP air deflector

Post by Richard Grace » Sat Jun 28, 2003 6:02 am

John, how can we contact Jim Causey?
Richard Grace
Palmetto, Georgia

John W. Rymark

JIM CAUSEY PARTS

Post by John W. Rymark » Sat Jun 28, 2003 2:54 pm

Richard, good to see you online. Have appreciated my parts from you. Richard, do you have a GP pintel hook? Please contact me at crymark@aol.com

Jim Causey can be contacted for GP reproduction parts, in California, at 530.532.9206

Best Regards,
John

Brian Wolf
G-Major
G-Major
Posts: 901
Joined: Fri Dec 13, 2002 8:16 pm
Location: Columbus, OH

Post by Brian Wolf » Mon Jun 30, 2003 8:59 pm

Thanks John,
I sure appreciate it. I was hoping that I might be able to line up an original before buying the repro. May end up going that route though.

Jacco, If jim is making them, then there is probably no sense in your guy making them as well. That is a VERY generous offer though. Do you think he could make the battery tray bracket? Not the tray itself, but the part that elevates it off the frame. Also might want to consider the gas tank shield. I think these are two parts that no one is making at the moment. and I know several people who could use them.

Brian
Brian


Post Reply

Return to “BRC MA GP Prototypes”

Who is online

Users browsing this forum: No registered users and 65 guests