Problem mountimng the Pioneer tool set to Pintle extension.
Moderator: Kurt Lesser
-
- Sergeant Major of the Gee
- Posts: 265
- Joined: Sun Aug 20, 2017 9:13 am
- Location: Rock Hill SC
Problem mountimng the Pioneer tool set to Pintle extension.
My rack for the Pioneer tool assembly is nice and straight, (but currently quite dirty) and fits in the forward pivot rack very well. The rubber bumpers align well with the two interior diagonal bumper braces on the airlift bumper, and the bolted on upper 'J' brackets are very close to aligning. My concern is that the lower over-center latches are not aligned in a parallel manner to the inner diagonal braces and I am not able to make them latch. Any suggestions? Thanks!
- Attachments
-
- Will'slatest 012.jpg (147.95 KiB) Viewed 523 times
-
- WCLouvers 006.jpg (152.48 KiB) Viewed 523 times
-
- WCLouvers 005.jpg (177.71 KiB) Viewed 523 times
-
- G-First Sergeant
- Posts: 131
- Joined: Sun Dec 04, 2016 1:34 pm
- Location: N'Awlins ( New Orleans)
Re: Problem mountimng the Pioneer tool set to Pintle extension.
You need a different set of 45* brackets in-between the tray / j bolt assembly and the bumper brackets. bracket part numbers 5583235 & 5583234
Basically the tray you have is for the original bumper and the trays for the airlift bumper are the same except for these brackets to offset the clasps.
Basically the tray you have is for the original bumper and the trays for the airlift bumper are the same except for these brackets to offset the clasps.
- Attachments
-
- IMG_0639.jpg (74.05 KiB) Viewed 519 times
-
- IMG_0636.jpg (66.73 KiB) Viewed 519 times
-
- Sergeant Major of the Gee
- Posts: 265
- Joined: Sun Aug 20, 2017 9:13 am
- Location: Rock Hill SC
Re: Problem mountimng the Pioneer tool set to Pintle extension.
Thanks, Juan. It was clear that something like that would be needed, but I was unable to find them in the TM's. Being a 'newbie' to the TM's my biggest problem is that I do not know the correct name/nomenclature for some of the items that I am interested in. Once more, you have been a GREAT help, and I am most appreciative. Thanks again!
Who is online
Users browsing this forum: No registered users and 50 guests