Problem mountimng the Pioneer tool set to Pintle extension.

1985 - Present, Questions, discussions, regarding anything related to the Humvee. (NO AUCTION or EBAY)

Moderator: Kurt Lesser

Post Reply
RockHillWill
Sergeant Major of the Gee
Sergeant Major of the Gee
Posts: 265
Joined: Sun Aug 20, 2017 9:13 am
Location: Rock Hill SC

Problem mountimng the Pioneer tool set to Pintle extension.

Post by RockHillWill » Thu Mar 01, 2018 9:38 am

My rack for the Pioneer tool assembly is nice and straight, (but currently quite dirty) and fits in the forward pivot rack very well. The rubber bumpers align well with the two interior diagonal bumper braces on the airlift bumper, and the bolted on upper 'J' brackets are very close to aligning. My concern is that the lower over-center latches are not aligned in a parallel manner to the inner diagonal braces and I am not able to make them latch. Any suggestions? Thanks!
Attachments
Will'slatest 012.jpg
Will'slatest 012.jpg (147.95 KiB) Viewed 515 times
WCLouvers 006.jpg
WCLouvers 006.jpg (152.48 KiB) Viewed 515 times
WCLouvers 005.jpg
WCLouvers 005.jpg (177.71 KiB) Viewed 515 times


JuanPrado
G-First Sergeant
G-First Sergeant
Posts: 131
Joined: Sun Dec 04, 2016 1:34 pm
Location: N'Awlins ( New Orleans)

Re: Problem mountimng the Pioneer tool set to Pintle extension.

Post by JuanPrado » Thu Mar 01, 2018 9:54 am

You need a different set of 45* brackets in-between the tray / j bolt assembly and the bumper brackets. bracket part numbers 5583235 & 5583234

Basically the tray you have is for the original bumper and the trays for the airlift bumper are the same except for these brackets to offset the clasps.
Attachments
IMG_0639.jpg
IMG_0639.jpg (74.05 KiB) Viewed 511 times
IMG_0636.jpg
IMG_0636.jpg (66.73 KiB) Viewed 511 times

RockHillWill
Sergeant Major of the Gee
Sergeant Major of the Gee
Posts: 265
Joined: Sun Aug 20, 2017 9:13 am
Location: Rock Hill SC

Re: Problem mountimng the Pioneer tool set to Pintle extension.

Post by RockHillWill » Thu Mar 01, 2018 11:36 am

Thanks, Juan. It was clear that something like that would be needed, but I was unable to find them in the TM's. Being a 'newbie' to the TM's my biggest problem is that I do not know the correct name/nomenclature for some of the items that I am interested in. Once more, you have been a GREAT help, and I am most appreciative. Thanks again!


Post Reply

Return to “Humvee Technical Knowledge Base -”

Who is online

Users browsing this forum: No registered users and 62 guests