2-door to 4-door conversion
Moderator: Kurt Lesser
-
- Sergeant Major of the Gee
- Posts: 265
- Joined: Sun Aug 20, 2017 9:13 am
- Location: Rock Hill SC
2-door to 4-door conversion
As previously mentioned, I have purchased a two door truck outfitted for carrying troops and want to first install a helmet top for some photos and them install the parts to convert it to an M1025. I still have to wait for the EUC to be confirmed, but my question is what do I need to be looking for to add the rear seats to this vehicle? Will there be any components reusable? Are the seat bottom/base in place?
- lkgindy
- G-Lieutenant Colonel
- Posts: 1038
- Joined: Mon Oct 24, 2005 4:27 pm
- Location: Indianapolis, Indiana
Re: 2-door to 4-door conversion
The seat back panels should already be in place since they make up part of the truck bed floor. They just lift up and are held in place by twist pins. The seat back cushion attaches to this panel. The seat bottom should already be in place in the form of a box with lid attached. The lower seat cushions attach to this lid.
Larry
Larry
1987 M-998 Project
1995 Hummer HT
1995 Hummer HT
-
- Sergeant Major of the Gee
- Posts: 265
- Joined: Sun Aug 20, 2017 9:13 am
- Location: Rock Hill SC
Re: 2-door to 4-door conversion
Thanks, Larry. That is what I had suspected, and it will make my search a little easier.
-
- G-First Sergeant
- Posts: 131
- Joined: Sun Dec 04, 2016 1:34 pm
- Location: N'Awlins ( New Orleans)
Re: 2-door to 4-door conversion
If you need a seat lid back with cushion, I have a used set.
Who is online
Users browsing this forum: Google Adsense [Bot] and 46 guests