I would like to make the small plate the clamp for the crank is screwed on myself. But I can't find the dimensions. Would anybody measure an example for me (metric please)?
So it's the small plate welded to the back.
Dimensions needed (crank mounting)
-
- G-Staff Sergeant
- Posts: 55
- Joined: Fri Nov 17, 2017 2:35 pm
- Location: Liechtenstein
Dimensions needed (crank mounting)
1943 MB 254813 (DOD 9th August 1943, educated guess), engine MB 278234 (former: MB 573953)
- dpcd67
- G-General
- Posts: 11811
- Joined: Mon Jul 25, 2011 3:41 pm
- Location: Iowa
Re: Dimensions needed (crank mounting)
Jeep Draw has this drawing, I think. Ask Jon.
U. S. Army 28 years.
Armor Branch
Armor Branch
-
- G-Sergeant Major
- Posts: 195
- Joined: Mon Jul 11, 2016 4:20 pm
- Location: south central Texas
Re: Dimensions needed (crank mounting)
pfnaak;
Here are the measurements from my GPW. These are take looking from the face of the plate. Measurements are in mm.
From the top down:
14 mm to the first bend
14 mm to the 2nd bend
the 5/16 inch threaded rod is 22 mm down from the 2nd bend and is 1 inch or 25.40 mm long
from the 2nd bend to the bottom of the plate is 66.6 mm
the plate is 32 mm wide
Hope this helps.
Here are the measurements from my GPW. These are take looking from the face of the plate. Measurements are in mm.
From the top down:
14 mm to the first bend
14 mm to the 2nd bend
the 5/16 inch threaded rod is 22 mm down from the 2nd bend and is 1 inch or 25.40 mm long
from the 2nd bend to the bottom of the plate is 66.6 mm
the plate is 32 mm wide
Hope this helps.
Last edited by semberae on Mon Feb 12, 2018 2:01 pm, edited 1 time in total.
-
- G-Staff Sergeant
- Posts: 55
- Joined: Fri Nov 17, 2017 2:35 pm
- Location: Liechtenstein
Re: Dimensions needed (crank mounting)
It really does, thank you!
But just to get it right, what are the measurements for E and G?
1943 MB 254813 (DOD 9th August 1943, educated guess), engine MB 278234 (former: MB 573953)
-
- G-Sergeant Major
- Posts: 195
- Joined: Mon Jul 11, 2016 4:20 pm
- Location: south central Texas
Re: Dimensions needed (crank mounting)
E. 38 mm
G. 90 mm approx. following bends
82.7 mm top to bottom with bends
I corrected the threaded rod distance from the 2nd bend
G. 90 mm approx. following bends
82.7 mm top to bottom with bends
I corrected the threaded rod distance from the 2nd bend
Who is online
Users browsing this forum: dinof, Google Adsense [Bot], loose nut dan, Overland and 67 guests