G503 Military Vehicle Message Forums

I am trying to correct a Bubba. Can anyone tell me where the stud for the windshield adjusting arm is welded to the bracket? I know the outside is swagged, but can't find any info on how it was spot welded. A picture would be great.
Thanks

Does anyone have a picture of how this stud is welded to the bracket ???

Could someone please take a picture of this stud and bracket at the weld?

[Post Deleted By Author]

A big thank you!!!
Now that is what I was talking about. Thanks Farrell Fox, that's exactly what I needed. Now I can set the studs and weld them like the factory did.

Hello all,
I'm removing the Hotchkiss windshield assembly that if fitted to my '44 MB as a temporary fix about 13yrs ago, and restoring the original one.
On my original screen the adjusting arms were missing so I only have the Hotchkiss one to go by. My question is ... what holds the adjusting arms to the INNER frame on an original wartime screen please.

Thanks
Kings

This bracket (Windshield bracket adjusting arm with bushing -A4300) is bolted to the inner frame. Ron has this for sale.
You can see it in the bottom photo of Farrell Fox's post.
Hope this helps.

Hello and thanks for the reply. Sorry I didn't explain correctly. I have that part on the inner frame. I'll try again.
In the pics above it looks like a screw that screws through the adjusting arm. Obviously with a step on it so the arm is free to move.
On my Hotchkiss screen it's Stud/rivet.

Thanks all

The Windshield adjusting swing arm(# -A2235) slides on the windshield adjusting arm stud. The windshield adjusting swing arm is bolted to the bracket on the inner windshield.
Hope this helps.