Picked Up A '41 Can on Saturday

Manufacturers, production numbers, configurations, etc.
User avatar
d42jeep
G-Lieutenant Colonel
G-Lieutenant Colonel
Posts: 1128
Joined: Tue Feb 25, 2014 6:06 pm
Location: Albany/Fallen Leaf Lake, CA
Contact:

Re: Picked Up A '41 Can on Saturday

Post by d42jeep » Thu Apr 20, 2017 10:12 am

Thanks for your reply, Luca. I wondered if it was factory.
-Don
Ford GPW 76344 DOD 11/42 Built in Richmond, CA

User avatar
d42jeep
G-Lieutenant Colonel
G-Lieutenant Colonel
Posts: 1128
Joined: Tue Feb 25, 2014 6:06 pm
Location: Albany/Fallen Leaf Lake, CA
Contact:

Re: Picked Up A '41 Can on Saturday

Post by d42jeep » Thu May 04, 2017 2:02 am

My wife and I were poking around an Antique store in Crockett, CA yesterday and I spotted a kind of rusty OD can. I checked the inside and it wasn't too bad so I picked it and a 10" Ridgid pipe wrench up for $10.00. After a little clean up at home I found the the manufacturer's markings were all under the handles rather than on the bottom. It is marked N. S. I. The other markings look like ICC 5, 20 5-1/4 43. Here are some pictures.
-Don
Attachments
IMG_3960.JPG
Stenciled markings
IMG_3960.JPG (112.67 KiB) Viewed 393 times
IMG_3959.JPG
QMC side
IMG_3959.JPG (151.2 KiB) Viewed 393 times
IMG_3963.JPG
USA side
IMG_3963.JPG (204.64 KiB) Viewed 393 times
IMG_3962.JPG
Date markings
IMG_3962.JPG (134.75 KiB) Viewed 393 times
IMG_3958.JPG
NSI marking
IMG_3958.JPG (147.4 KiB) Viewed 393 times
Ford GPW 76344 DOD 11/42 Built in Richmond, CA

Chuck Lutz
Gee Addict
Posts: 23735
Joined: Wed Jun 28, 2006 8:00 am
Location: Novato, CA

Re: Picked Up A '41 Can on Saturday

Post by Chuck Lutz » Sat May 06, 2017 4:39 pm

Noblitt Sparks Industrial
Chuck Lutz

GPW 17963 4/24/42 Chester, PA. USA 20113473 (USA est./Tom W.)
GPW 108552 4/17/43 Louisville, KY. USA 20371278 (DOD est./Tom W.)
Bantam T3 4582 10/29/42 USA 0173499 (est.)

User avatar
d42jeep
G-Lieutenant Colonel
G-Lieutenant Colonel
Posts: 1128
Joined: Tue Feb 25, 2014 6:06 pm
Location: Albany/Fallen Leaf Lake, CA
Contact:

Re: Picked Up A '41 Can on Saturday

Post by d42jeep » Thu Oct 05, 2017 6:53 am

This problem is a little bit off topic but I'm hoping that someone might have an idea for a source of gas resistant rubber material to make new gaskets for my USMC Blitz small cans from the 80s. I picked up the new looking one recently but I've had the Fuel & Tool can for 27 years. Both cans' gaskets are now split and leaking. Any suggestions?
-Don
Attachments
IMG_5944.JPG
IMG_5944.JPG (35.42 KiB) Viewed 266 times
IMG_5942.JPG
IMG_5942.JPG (112.19 KiB) Viewed 266 times
IMG_5941.JPG
IMG_5941.JPG (141.7 KiB) Viewed 266 times
Ford GPW 76344 DOD 11/42 Built in Richmond, CA

JerryKans
Sergeant Major of the Gee
Sergeant Major of the Gee
Posts: 264
Joined: Sun Feb 13, 2005 9:46 pm
Location: Washington

Re: Picked Up A '41 Can on Saturday

Post by JerryKans » Wed Nov 22, 2017 8:31 am

You can buy a sheet of rubberized cork material that should work fine. I've used it for fuel gaskets. A good hardware store should have it.
'43 MB, '45 MB, '52 M-38, '51 M-100, '41 GMC CCKW 352


User avatar
d42jeep
G-Lieutenant Colonel
G-Lieutenant Colonel
Posts: 1128
Joined: Tue Feb 25, 2014 6:06 pm
Location: Albany/Fallen Leaf Lake, CA
Contact:

Re: Picked Up A '41 Can on Saturday

Post by d42jeep » Wed Dec 13, 2017 2:02 pm

Thanks for the suggestion. I'll give it a shot.
-Don
Ford GPW 76344 DOD 11/42 Built in Richmond, CA

User avatar
philbrinson
Sergeant Major of the Gee
Sergeant Major of the Gee
Posts: 342
Joined: Wed Oct 22, 2008 8:02 pm
Location: Southeast GA

Re: Picked Up A '41 Can on Saturday

Post by philbrinson » Mon Dec 25, 2017 6:39 pm

Do a search on Amazon for Jerry can gaskets. Plenty of results.

Phil
1937 Quartermaster Cart
1941 WC12 1941 WC21
1941 MB 1942 GPW
1942 G506 1942 Ben Hur
1943 M3A1 1943 Clark CA-1
1943 USMC Handcart
1944 Ben Hur 1944 Converto
1952 M100

User avatar
John Neuenburg
Gee Old Hand
Posts: 2749
Joined: Mon Mar 24, 2003 1:18 pm
Location: U.S. Left Coast

Re: Picked Up A '41 Can on Saturday

Post by John Neuenburg » Thu Jan 04, 2018 11:14 pm

Don since you are scrounging all the good stuff around the Bay Area, the least you can do is to bring these treasures to Camp Petaluma in April so we with less time on our hands will have a chance to double your investment.
Military Vehicle Collectors of California

Image
44 Ford M20
42 GPW, Special Air Service replica
41 Indian 640
BSA folding bikes

User avatar
lucakiki
G-General
G-General
Posts: 17498
Joined: Sat Feb 15, 2003 9:18 am
Location: Torino, ITALY

Re: Picked Up A '41 Can on Saturday

Post by lucakiki » Fri Feb 23, 2018 8:13 am

d42jeep wrote:
Thu May 04, 2017 2:02 am
My wife and I were poking around an Antique store in Crockett, CA yesterday and I spotted a kind of rusty OD can. I checked the inside and it wasn't too bad so I picked it and a 10" Ridgid pipe wrench up for $10.00. After a little clean up at home I found the the manufacturer's markings were all under the handles rather than on the bottom. It is marked N. S. I. The other markings look like ICC 5, 20 5-1/4 43. Here are some pictures.
-Don
I only saw your post now: very nice can, and the marking under the handles makes it a bit more interesting that the usual plain jane gas cans. However I am puzzled by the four unrolled tabs on the lid, with their chain attacment, typical of 1941 cans. Maybe it has been replaced, as it does not look stock to me.
Luca

WillysMB#344142 6-19-44 Navy N.S.Blue Grey
45 Bantam T-3 #57248 1-10-45
42 Willys MB-T #13560 11-42
43 Willys MB-T # 25417 4-43
Way too many WWII military tools,hopefully thinning down,and way too many posts...

__________________________________________
_____________________________________________
__________________________________________

User avatar
lt.luke
G-General
G-General
Posts: 8903
Joined: Fri May 09, 2003 8:56 am
Location: O K lahoma
Contact:

Re: Picked Up A '41 Can on Saturday

Post by lt.luke » Fri Feb 23, 2018 10:48 am

lucakiki wrote:
Fri Feb 23, 2018 8:13 am
d42jeep wrote:
Thu May 04, 2017 2:02 am
My wife and I were poking around an Antique store in Crockett, CA yesterday and I spotted a kind of rusty OD can. I checked the inside and it wasn't too bad so I picked it and a 10" Ridgid pipe wrench up for $10.00. After a little clean up at home I found the the manufacturer's markings were all under the handles rather than on the bottom. It is marked N. S. I. The other markings look like ICC 5, 20 5-1/4 43. Here are some pictures.
-Don
I only saw your post now: very nice can, and the marking under the handles makes it a bit more interesting that the usual plain jane gas cans. However I am puzzled by the four unrolled tabs on the lid, with their chain attacment, typical of 1941 cans. Maybe it has been replaced, as it does not look stock to me.
and is probably worth his peanuts investment by itself!
Luke Sparks
MAJ, FA

GPW Script 12078 viewtopic.php?f=95&t=102532
2 WWII 1/4T
Dog Pack

Post Reply

Return to “Gerry Cans or Jerry Cans”

Who is online

Users browsing this forum: No registered users and 1 guest