Is there a difference between a G506 and G508 front fender? I was always under the impression the former is slightly shorter than the latter. Is that correct?
John
G506 vs. CCKW front fenders?
-
- G-Colonel
- Posts: 1794
- Joined: Sat Feb 24, 2007 8:14 am
- Location: Becket, MA
-
- Jeep Heaven
- Posts: 49841
- Joined: Sun Mar 02, 2008 12:37 pm
- Location: Proving Ground
Re: G506 vs. CCKW front fenders?
Same length, same hole pattern, the only noticeable difference is the doubler or reinforcing plate found under the front two or three inches of the CCKW fender. I installed a NOS of each type on my CCKW. The Chevrolet fender is on the right side.
Don't be afraid to mix the fender makes on a G-506 or G-508, few realize the difference. Dr Deuce has discovered that the reinforcing plate attracts rust, didn't you Dr. Deuce.
Don't be afraid to mix the fender makes on a G-506 or G-508, few realize the difference. Dr Deuce has discovered that the reinforcing plate attracts rust, didn't you Dr. Deuce.
2011 MVPA PIONEER AWARD - MVPA #1064
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
-
- Jeep Heaven
- Posts: 49841
- Joined: Sun Mar 02, 2008 12:37 pm
- Location: Proving Ground
Re: G506 vs. CCKW front fenders?
For those who are curious about G-506 and G-508 Fenders.
2011 MVPA PIONEER AWARD - MVPA #1064
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
-
- G-First Lieutenant
- Posts: 615
- Joined: Fri Jan 30, 2004 9:49 am
- Location: Pembroke NH USA
- Contact:
Re: G506 vs. CCKW front fenders?
The CCKW reenforcing at the front indeed holds stuff that will rot out the top of the fender. The Chev does not have this piece. Because of that, the Chev will crack just outboard of the outside grill mounting bolt.
Stephen Keith AKA Dr Deuce
www.ww2movievehicles,com
9 CCKWs 6x6
7 Chevys 4x4
www.ww2movievehicles,com
9 CCKWs 6x6
7 Chevys 4x4
Who is online
Users browsing this forum: No registered users and 46 guests