Page 1 of 1

Oil Filter Canister and Steering Casting

Posted: Wed Sep 06, 2017 5:38 am
by Jerry Hudgens
See the two attached photos below.

The oil filter canister has been sand-blasted and primed with red oxide primer. There is no rust but there is some pitting on the outside. The inside is clean and no rust. The cover is in decent shape and has been sandblasted and treated with iron phosphate.

Asking $5.00 for the canister and cover

The Steering housing has been sandblasted and treated with iron phosphate. The arm has the letter R. All threaded holes in excellent condition. This housing is in first class shape.

Asking $5.00 for the steering housing.

I will accept a personal check or a money order but not PayPal. You pay for shipping.

Thanks

Jerry Hudgens
BottomView.JPG
BottomView.JPG (93.25 KiB) Viewed 1129 times
TopView.JPG
TopView.JPG (89.6 KiB) Viewed 1129 times

Re: Oil Filter Canister and Steering Casting

Posted: Wed Sep 13, 2017 3:35 am
by Thebarn
Is this for a gpw I'm new at the jeep thing and I'm restoring a gpw for someone and it's a 41 gpw thanks

Re: Oil Filter Canister and Steering Casting

Posted: Wed Sep 13, 2017 5:16 pm
by Jerry Hudgens
Thebern

No, these are not for GPW or MB. Not sure what the oil canister goes on but the steering casting is for a Cj2

Jerry Hudgens

Re: Oil Filter Canister and Steering Casting

Posted: Thu Sep 14, 2017 8:08 am
by Bruce W
Jerry,
I will take the steering knuckle housing. Please PM me your mailing address and a total with shipping and I will get funds on the way.
I think the oil filter canister may be for a Ford Flathead V8. I've been meaning to dig one out for comparison, but haven't gotten a round tuitt. BW

Re: Oil Filter Canister and Steering Casting

Posted: Thu Sep 14, 2017 8:25 am
by Jerry Hudgens
Bruce W

I will try to get to the post office today. I have a Doctor's appointment at 2:00 P.M. so I should be able to find out the shipping costs today.

Thanks

Jerry

Re: Oil Filter Canister and Steering Casting

Posted: Thu Sep 14, 2017 12:11 pm
by Bruce W
No rush Jerry, I don't have an immediate need for it, I just thought it might be good to have a spare. BW

Re: Oil Filter Canister and Steering Casting

Posted: Fri Sep 15, 2017 11:19 am
by Jerry Hudgens
Bruce

I went to the Post Office and I can get the steering knuckle in a medium flat rate box.

That is $13.60 for the flat rate box. That is the smallest box I can get it in. That is going to be the cheapest way to ship it. I have tried several times with the Post Office to price standard Parcel Post vs the flat rate boxes and it always comes out cheaper using the flat rate box.

So, total would be $13.60 Plus $5.00 which equals $18.60.

I sent you a private message with the details.

Let me know

Thanks

Jerry