MBP-4301UT Starter End Play
-
- G-Master Sergeant
- Posts: 107
- Joined: Sun May 14, 2017 4:58 am
- Location:
MBP-4301UT Starter End Play
Looking for the end play tolerances for the MBP-4301UT starter. Can you help? Thanks in advance.
-
- G-Master Sergeant
- Posts: 107
- Joined: Sun May 14, 2017 4:58 am
- Location:
Re: MBP-4301UT Starter End Play
Could it be .010 to .020? I found this spec for an autolite starter used on an old tractor...just guessing. Thanks
-
- G-Colonel
- Posts: 1931
- Joined: Mon Dec 18, 2006 5:06 pm
- Location: San Mateo, Ca
Re: MBP-4301UT Starter End Play
0.005-0.030. Source TM-9-1825B Electrical Equipment(Auto-Lite) November 1952.
-
- G-Master Sergeant
- Posts: 107
- Joined: Sun May 14, 2017 4:58 am
- Location:
Re: MBP-4301UT Starter End Play
I have an excerpt of the TM from another forum site but data such as this is absent. Thanks for helping out.
-
- G-Master Sergeant
- Posts: 107
- Joined: Sun May 14, 2017 4:58 am
- Location:
Re: MBP-4301UT Starter End Play
Last question. I don't have a travel gage for the pinion to adjust the yoke lever stop. In the absence of the gage, couldn't I measure the travel distance of the pinion Bendix and adjust accordingly? If so, what is that measurement? Thanks
Who is online
Users browsing this forum: No registered users and 36 guests