Master battery disconnect switch
-
- Sergeant Major of the Gee
- Posts: 489
- Joined: Sat Jun 09, 2012 6:43 pm
- Location:
Master battery disconnect switch
Does anyone use a Master Battery Disconnect switch? If yes, what type? Pictures if at all possible please> Thank you.
- artificer
- banned
- Posts: 13558
- Joined: Tue Jul 11, 2006 10:46 am
- Location: SINGAPORE
Re: Master battery disconnect switch
I used to & it was a marine type thing & needed a key to re-activate something like this but better quality....
https://www.amazon.com/dp/B01IBOH5EA?psc=1
https://www.amazon.com/dp/B01IBOH5EA?psc=1
John GIBBINS Member Institute of Automotive Mechanical Engineers [Ret], ASE Master Medium/Heavy Truck & Auto Technician USA -2002 Licensed Motor Mech NSW MVIC 49593 Current 2015
TO DIAGNOSE, TROUBLESHOOT OR FAULT FIND ANY AUTO SYSTEM....
Understand how system parts interact with one another. GOOD parts can then be established & the NOT GOOD problem/s part/s isolated for repair or replacement.
TO DIAGNOSE, TROUBLESHOOT OR FAULT FIND ANY AUTO SYSTEM....
Understand how system parts interact with one another. GOOD parts can then be established & the NOT GOOD problem/s part/s isolated for repair or replacement.
-
- G-Lieutenant General
- Posts: 6907
- Joined: Sat Jan 12, 2008 5:25 am
- Location: Tipton,In.
Re: Master battery disconnect switch
I have seen two types. The one shown in John G's link ( with and without a key ) and an open knife switch type.
They can be bought at any auto parts store or I think I saw them at Harbor Freight.
The custom cars show guys use them as a safety factor. When they drive baby to a show, the switch is a quick, easy way to disconnect the battery while the car or jeep in your case is on display. They hide them where they can get to them but not obvious to an on looker.
Keeps some body from doing something they shouldn't ( Not that anyone would do that ), like accidently hitting the starter or starting the car or jeep and hitting people and other cars around them.
I would used the enclosed one in your case. Less likely to have something fall on it and short out.
Hint: they work on the ground side as well as the B+ side of the battery.
They can be bought at any auto parts store or I think I saw them at Harbor Freight.
The custom cars show guys use them as a safety factor. When they drive baby to a show, the switch is a quick, easy way to disconnect the battery while the car or jeep in your case is on display. They hide them where they can get to them but not obvious to an on looker.
Keeps some body from doing something they shouldn't ( Not that anyone would do that ), like accidently hitting the starter or starting the car or jeep and hitting people and other cars around them.
I would used the enclosed one in your case. Less likely to have something fall on it and short out.
Hint: they work on the ground side as well as the B+ side of the battery.
Mike Wolford
CJ-2A
VEP GPW
Comm./Inst. SEL
AOPA ( 50 yrs)
EAA ( 49 yrs)
4th Inf. Div. - 5th Inf. Div. - 2nd Armor Div. - CIB
CJ-2A
VEP GPW
Comm./Inst. SEL
AOPA ( 50 yrs)
EAA ( 49 yrs)
4th Inf. Div. - 5th Inf. Div. - 2nd Armor Div. - CIB
-
- Sergeant Major of the Gee
- Posts: 489
- Joined: Sat Jun 09, 2012 6:43 pm
- Location:
Re: Master battery disconnect switch
Thanks, I was going to use it on the ground side just in case something did touch it, it wouldn't short.
- Fred Coldwell
- G-Brigadier General
- Posts: 2408
- Joined: Sat Dec 14, 2002 5:12 am
- Location: Denver, Colorado, USA
Re: Master battery disconnect switch
I simply remove the ground (-) battery cable whenever I'm not going to fire up the jeep the next day. This allows me to clean off any corrosion on the - battery cable clamp or the - battery post each time I re-attach the - battery cable for use that day. Detaching and re-attaching the - battery cable with my standard length 1/2 inch SAE wrench avoids any risk of accidentally grounding that wrench to the jeep when removing the + battery cable, which would produce a dead short and large sparks if the - battery cable is not removed first.
I leave the positive (+) battery cable attached all the time, except for twice a year, when I remove it to clear corrosion off the + battery terminal and + battery cable clamp. Before removing the + battery cable, I double-check to MAKE SURE the - battery cable has already been detached so I do not accidentally ground the metal wrench from the + battery cable to anywhere else on the jeep, producing a dead short and those terrible large bright sparks.
I leave the positive (+) battery cable attached all the time, except for twice a year, when I remove it to clear corrosion off the + battery terminal and + battery cable clamp. Before removing the + battery cable, I double-check to MAKE SURE the - battery cable has already been detached so I do not accidentally ground the metal wrench from the + battery cable to anywhere else on the jeep, producing a dead short and those terrible large bright sparks.
Happy Jeep Trails,
Fred Coldwell
1944 CJ2-09 - X33
1945 CJ2-26 - X50
1944 Dodge T233 CC
1945 Dodge T233 Utility
MVPA #283C
Fred Coldwell
1944 CJ2-09 - X33
1945 CJ2-26 - X50
1944 Dodge T233 CC
1945 Dodge T233 Utility
MVPA #283C
- artificer
- banned
- Posts: 13558
- Joined: Tue Jul 11, 2006 10:46 am
- Location: SINGAPORE
Re: Master battery disconnect switch
John GIBBINS Member Institute of Automotive Mechanical Engineers [Ret], ASE Master Medium/Heavy Truck & Auto Technician USA -2002 Licensed Motor Mech NSW MVIC 49593 Current 2015
TO DIAGNOSE, TROUBLESHOOT OR FAULT FIND ANY AUTO SYSTEM....
Understand how system parts interact with one another. GOOD parts can then be established & the NOT GOOD problem/s part/s isolated for repair or replacement.
TO DIAGNOSE, TROUBLESHOOT OR FAULT FIND ANY AUTO SYSTEM....
Understand how system parts interact with one another. GOOD parts can then be established & the NOT GOOD problem/s part/s isolated for repair or replacement.
-
- G-Command Sergeant Major
- Posts: 234
- Joined: Tue May 26, 2015 12:00 pm
- Location: Denmark
Re: Master battery disconnect switch
I have something of a similar design but installed by the French army. It disconnects my battery + from all other connections. The alternator and the large + supplying the dash (through the amp meter) both connect to this, with the battery + on the other post. It's hidden under the dash, in the passenger side - I can still reach over and flip it, though.artificer wrote:I used to & it was a marine type thing & needed a key to re-activate something like this but better quality....
https://www.amazon.com/dp/B01IBOH5EA?psc=1
- Martin MB in UK
- Sergeant Major of the Gee
- Posts: 361
- Joined: Wed Aug 13, 2003 9:36 am
- Location: North West England
Re: Master battery disconnect switch
This is what I use. Mounted behind the air cleaner so you cant see it, and up behind the dash. Small chain on the red key, mounted so when the key is in, it is horizontal, and a small tug on the chain pulls the key down and out, in case you need to disable the battery quickly. Never had any problems. If you want a photo, I'll get some, my air cleaner is out at the moment anyway.
Martin Russell
English Lake District,
Near Beela POW Camp
'42 Willys MB 163086
'65 Mustang 2+2 V8
Fat Bob Harley
English Lake District,
Near Beela POW Camp
'42 Willys MB 163086
'65 Mustang 2+2 V8
Fat Bob Harley
-
- Sergeant Major of the Gee
- Posts: 489
- Joined: Sat Jun 09, 2012 6:43 pm
- Location:
- Martin MB in UK
- Sergeant Major of the Gee
- Posts: 361
- Joined: Wed Aug 13, 2003 9:36 am
- Location: North West England
Re: Master battery disconnect switch
This is what it looks like when the air cleaner assembly is off. The little orange cable goes to a 12v cig socket under the dash. big cable from battery to switch, then the other big cable to the starter floor button. Simple.
trying to upload a pic. Just be careful when putting the air cleaner back in, that you don't touch the 2 terminals, get a bit of a spark. It clears it no problem, only sparked once, learnt to be a bit more careful after that.
trying to upload a pic. Just be careful when putting the air cleaner back in, that you don't touch the 2 terminals, get a bit of a spark. It clears it no problem, only sparked once, learnt to be a bit more careful after that.
Martin Russell
English Lake District,
Near Beela POW Camp
'42 Willys MB 163086
'65 Mustang 2+2 V8
Fat Bob Harley
English Lake District,
Near Beela POW Camp
'42 Willys MB 163086
'65 Mustang 2+2 V8
Fat Bob Harley
-
- Sergeant Major of the Gee
- Posts: 489
- Joined: Sat Jun 09, 2012 6:43 pm
- Location:
-
- G-Captain
- Posts: 787
- Joined: Thu Sep 01, 2011 8:40 am
- Location: South West England
Re: Master battery disconnect switch
I use a simple cut-off switch which works with a bridge screw, which you can undo and carry in your pocket - no holes to drill and not expensive
see e-Bay #111732970085
see e-Bay #111732970085
Rod Rushton - Winner 2013 MVT Wilkinson Sword Trophy
Exeter Devon UK
FORD GPW 202055 DoD 5 - 22 - 44 Serial# 20534360
MBT # 25553 DoD 4 - 43
Piper Cub 1944 L4H 480015 G-AKIB
1942 CHEVROLET G506 CARGO. #2NM 213219
1943 AUSTIN LIGHT UTILITY M6448770
Exeter Devon UK
FORD GPW 202055 DoD 5 - 22 - 44 Serial# 20534360
MBT # 25553 DoD 4 - 43
Piper Cub 1944 L4H 480015 G-AKIB
1942 CHEVROLET G506 CARGO. #2NM 213219
1943 AUSTIN LIGHT UTILITY M6448770
- Gordon_M
- G-Colonel
- Posts: 1840
- Joined: Thu Feb 26, 2004 9:32 am
- Location: central and north east Scotland, depending on the day
Re: Master battery disconnect switch
If you want a contemporary switch I used the one from the Weasel dash which was ideal.
One thing though, all these switches have a voltage drop, I measured almost 0.5 volt. That's fine on a 12v or 24v system, but when you are only starting with 6v you may be better off just pulling a battery terminal clamp off.
One thing though, all these switches have a voltage drop, I measured almost 0.5 volt. That's fine on a 12v or 24v system, but when you are only starting with 6v you may be better off just pulling a battery terminal clamp off.
Gordon
1941 Highway Trailer K-38
1944 Iron Fireman T-36 Snow Tractor
1986 Nolan Road/Rail trailer
1941 Highway Trailer K-38
1944 Iron Fireman T-36 Snow Tractor
1986 Nolan Road/Rail trailer
-
- Sergeant Major of the Gee
- Posts: 489
- Joined: Sat Jun 09, 2012 6:43 pm
- Location:
Re: Master battery disconnect switch
Ok, thank you.